4) You will need to have on hand emergency service tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
If you find that the water line repair leak is in the supply line you will need to replace it or simply tighten it. Start by turning the water supply off and then flushing the toilet to get rid of the excess water. Now use the towels to dry the area so that it is easier for you to fix the leak. Use a wrench to loosen the hexagonal nuts on the supply line at the main end as well as the one which goes to the flush tank. Now use the replacement supply line which you have and tighten the bolt at the supply end first. Now adjust the length that you will need for the pipe to reach the flush tank. Once you adjust the length use a knife to cut the extra length and then tighten the hexagonal bolt at the other end.
In repairing a tub faucet, you will notice that there will be drips that you need to address to. With this, you will need to replace the washers and/or seats.
Working on the gas lines is also a complex job that only a licensed plumber can handle because it is very dangerous. Small leaks can't always be detected by odor alone, but a licensed professional has the proper equipment that's needed to ensure that you don't have any leaks in the line.
Ventilation and insulation are important throughout your house, and especially in crawl spaces and attics. If you have a crawl space in your home, it's best to water line repair the floor with a good quality, heavy-duty plastic. Inside your home, make sure to use the exhaust fans found in most kitchens, bathroom and laundry rooms.
The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.